TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-04 Machine Articula-
11. Connect secondary steering har-
tion Angle Sensor Voltage
ness connector AT-C3 (WP 0009,
Below Normal - Continued
Figure 144) to articulation angle
position sensor 1 (left) (WP 0009,
Figure 145) (WP 0257).
12. Connect rear chassis wiring har-
ness connector FA-C22 (WP
0009, Figure 47) to cab lower wir-
ing harness connector P-C69
(WP 0009, Figure 46), and install
rear bulkhead cover plate (WP
0266).
13. Connect cab lower wiring harness
connector P-C41 (WP 0009, Fig-
ure 68) to Implement 1 ECM J1
(WP 0009, Figure 69) (WP 0268).
14. Connect MSD (WP 0006). Select
0615-04 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
0615-04 is active.
diagnostic code.
0615-04 Code Not Active - Trouble-
shooting complete.
System Response:
0615-08 Machine Articula-
tion Angle Sensor Abnor-
ECM will log a diagnostic code.
mal Frequency, Pulse Width
or Period
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 0615-08
is Active.
1. Connect MSD (WP 0006). Select
0041-03 or 0041-04 Code Active -
Implement 120M and verify 0041-
Diagnose 0041-03 or 0041-04 (WP
03 or 0041-04 is active in the
0026) for the Implement ECM first.
Implement 120M ECM.
0041-03 or 0041-04 Code Not Active
- Proceed to step 2.