TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-04 Machine Articula-
b. Remove articulation angle
Sensor Damaged - Replace articula-
tion Angle Sensor Voltage
position sensor 1 (left) and
tion angle position sensor 1 (left) (WP
Below Normal - Continued
visually inspect sensor hous-
0257).
ing, and harness connector
Proceed to step 2.
for damage (WP 0257).
c.
Linkage bent or damaged.
Linkage Bent or Damaged - Replace
articulation angle position sensor 1
(left) linkage and perform adjustment
(WP 0257).
Proceed to step 2.
Sensor and Linkage OK - Proceed to
Test Step 3.
2. Using MSD (WP 0006), verify
0615-04 Code Active - Proceed to
0615-04 is active for the transmis-
Test Step 3.
sion ECM or the Implement 1
0615-04 Code Not Active - Trouble-
ECM.
shooting complete.
Test Step 3. Check Sensor.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect secondary steering
harness connector AT-C3 (WP
0009, Figure 144) from articula-
tion angle position sensor 1 (left)
(WP 0009, Figure 145) (WP
0257).
3. Turn battery disconnect switch
and ignition switch to the ON posi-
tion (TM 5-3805-293-10).
4. Using MSD (WP 0006), verify
0615-04 Code Active - Proceed to
0615-04 is active.
Test Step 4.
0615-04 Code Not Active - Replace
articulation angle sensor 1 (left) (WP
0257).
Proceed to step 5.
5. Connect MSD (WP 0006). Select
0615-04 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
0615-04 is active.
diagnostic code.
0615-04 Code Not Active - Trouble-
shooting complete.
Test Step 4. Check Sensor Signal
Circuit.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
0017-53