TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-08 Machine Articula-
2. Using MSD (WP 0006), verify
0615-08 Code Active - Proceed to
tion Angle Sensor Abnor-
0615-08 is active for the transmis-
Test Step 2.
mal Frequency, Pulse Width
sion ECM or the Implement 1
0615-08 Code Not Active - Trouble-
or Period - Continued
ECM.
shooting complete.
Test Step 2. Inspect Sensor and
Linkage.
1. Inspect articulation angle position
sensor 1 (left) (WP 0009, Figure
145) and linkage for the following:
Linkage Loose or Sensor Not
a. Linkage securely connected
to machine and to sensor.
Secure - Perform installation and
adjustment procedures for articula-
tion angle position sensor 1 (left) (WP
0257).
Proceed to step 2.
b. Remove articulation angle
Sensor Damaged - Replace articula-
position sensor 1 (left) and
tion angle position sensor 1 (left) (WP
visually inspect sensor hous-
0257).
ing, and harness connector
Proceed to step 2.
for damage (WP 0257).
c.
Linkage bent or damaged.
Linkage Bent or Damaged - Replace
articulation angle position sensor 1
(left) linkage and perform adjustment
(WP 0257).
Proceed to step 2.
Sensor and Linkage OK - Proceed to
Test Step 3.
2. Using MSD (WP 0006), verify
0615-08 Code Active - Proceed to
0615-08 is active for the transmis-
Test Step 3.
sion ECM or the Implement 1
0615-08 Code Not Active - Trouble-
ECM.
shooting complete.
Test Step 3. Check Sensor.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect secondary steering
harness connector AT-C3 (WP
0009, Figure 144) from left articu-
lation angle position sensor (WP
0009, Figure 145) (WP 0257).
3. Install a jumper wire between har-
ness connector AT-C3 (WP 0009,
Figure 144) terminal A and termi-
nal C.
0017-57