TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-13 Machine Articula-
System Response:
tion Angle Sensor Out Of
ECM will log a diagnostic code.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 0615-13
is Active.
0615-13 Code Active - Proceed to
Trans/Chassis 120M and verify
Test Step 2.
0615-13 is active for the transmis-
0615-13 Code Not Active - Trouble-
sion ECM or the Implement 1
shooting complete.
ECM.
Test Step 2. Inspect Sensor and
Linkage.
1. Inspect articulation angle position
145) and linkage for the following:
a. Linkage securely connected
Linkage Loose or Sensor Not
to machine and to sensor.
Secure - Perform installation and
adjustment procedures for articula-
tion angle position sensor 1 (left) (WP
0257).
Proceed to step 2.
b. Remove articulation angle
Sensor Damaged - Replace articula-
position sensor 1 (left) and
tion angle position sensor 1 (left) (WP
visually inspect sensor hous-
0257).
ing, and harness connector
Proceed to step 2.
for damage (WP 0257).
c.
Linkage bent or damaged.
Linkage Bent or Damaged - Replace
articulation angle position sensor 1
(left) linkage (WP 0257).
Proceed to step 2.
Sensor and Linkage OK - Proceed to
Test Step 3.