TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-04 Machine Articula-
tion Angle Sensor Voltage
continuity between harness con-
wiring harness (WP 0188).
Below Normal - Continued
Connect cab lower wiring harness
124) terminal 41 and all other ter-
minals on FA-C21 and to machine
70) to Implement 1 ECM J2 (WP
ground.
0009, Figure 71) (WP 0268).
There should be no continuity.
Connect secondary steering harness
144) to left articulation angle position
0257).
Proceed to step 14.
continuity between harness con-
steering wiring harness (WP 0186).
Connect rear chassis wiring harness
110) terminal 7 and all other termi-
nals on AT-C1 and to machine
47) to cab lower wiring harness con-
ground.
There should be no continuity.
and install rear bulkhead cover plate
(WP 0266).
Connect cab lower wiring harness
68) to Implement 1 ECM J1 (WP
0009, Figure 69) (WP 0268).
Connect harness connector FA-C21
Proceed to step 14.
0615-04 Was Active for the Trans-
0615-04 was active for the Trans-
mission ECM Only - Replace trans-
mission ECM or the Implement 1
mission ECM (WP 0137).
ECM.
Proceed to step 11.
0615-04 Was Active for the Imple-
ment 1 ECM Only - Replace imple-
ment 1 ECM (WP 0268).
Proceed to step 11.
0615-04 Was Active for the Trans-
mission ECM and the Implement 1
ECM - Replace transmission ECM
(WP 0137) and implement 1 ECM
(WP 0268).
Proceed to step 11.
0017-55