TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-04 Machine Articula-
2. Disconnect harness connector
tion Angle Sensor Voltage
FA-C21 (WP 0009, Figure 124)
Below Normal - Continued
from transmission ECM J2 (WP
0009, Figure 112).
N OT E
Harness connector is located behind cab bulkhead cover on right rear
of cab.
3. Remove rear bulkhead cover
plate (WP 0266).
4. Disconnect rear chassis wiring
harness connector FA-C22 (WP
0009, Figure 47) from cab lower
wiring harness connector P-C69
(WP 0009, Figure 46) (WP 0188).
5. Disconnect cab lower wiring har-
ness connector P-C39 (WP 0009,
Figure 70) from Implement 1 ECM
J2 (WP 0009, Figure 71) (WP
0268).
6. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between harness con-
harness (WP 0266).
nector P-C39 (WP 0009, Figure
Connect harness connector FA-C21
70) terminal 41 and all other ter-
(WP 0009, Figure 124) to transmis-
minals on P-C39 and to machine
sion ECM J2 (WP 0009, Figure 112).
ground.
Connect secondary steering harness
There should be no continuity.
connector AT-C3 (WP 0009, Figure
144) to articulation angle position sen-
sor 1 (left) (WP 0009, Figure 145)
(WP 0257).
Proceed to step 14.
No Continuity - Proceed to step 7.
7. Disconnect rear chassis wiring
harness connector FA-C5 (WP
0009, Figure 111) from second-
ary steering wiring harness AT-C1
(WP 0009, Figure 110) (WP
0186).
0017-54