TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-08 Machine Articula-
4. Turn battery disconnect switch
tion Angle Sensor Abnor-
and ignition switch to the ON posi-
mal Frequency, Pulse Width
tion (TM 5-3805-293-10).
or Period - Continued
5. Using MSD (WP 0006), verify
0615-03 Code Active - Proceed to
0615-03 is active.
step 6.
0615-03 Code Not Active - Proceed
to step 10.
6. Remove jumper wire from har-
ness connector AT-C3 (WP 0009,
Figure 144) terminal A and termi-
nal C.
7. Install a jumper wire between har-
ness connector AT-C3 (WP 0009,
Figure 144) terminal B and termi-
nal C.
8. Using MSD (WP 0006), verify
0615-04 Code Active - Replace artic-
0615-04 is active.
ulation angle position sensor 1 (left)
(WP 0257).
Remove jumper wire from harness
connector AT-C3 (WP 0009, Figure
144) terminal B and terminal C.
Proceed to step 10.
0615-04 Code Not Active - Proceed
to step 9.
0017-58