TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-03 Machine Articula-
14. Using digital multimeter, test for
Resistance 5.0 Ohms or Less - Pro-
tion Angle Sensor Voltage
continuity between secondary
ceed to step 15.
Above Normal - Continued
steering wiring harness AT-C1
Resistance More Than 5.0 Ohms -
(WP 0009, Figure 110) verify ter-
Replace secondary steering wiring
minal 7 and harness connector
harness (WP 0186).
AT-C3 (WP 0009, Figure 144) ter-
Connect rear chassis wiring harness
minal C.
connector FA-C22 (WP 0009, Figure
Resistance should be less than
47) to cab lower wiring harness con-
5.0 ohms.
nector P-C69 (WP 0009, Figure 46),
and install rear bulkhead cover plate
(WP 0266).
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to Implement 1 ECM J1 (WP
0009, Figure 69) (WP 0268).
Connect harness connector FA-C21
(WP 0009, Figure 124) to transmis-
sion ECM J2 (WP 0009, Figure 112).
Proceed to step 19.
15. Using MSD (WP 0006), verify
0615-03 Was Active for the Trans-
0615-03 was active for the Trans-
mission ECM Only - Replace trans-
mission ECM or the Implement 1
mission ECM (WP 0137).
ECM.
Proceed to step 16.
0615-03 Was Active for the Imple-
ment 1 ECM Only - Replace imple-
ment 1 ECM (WP 0268).
Proceed to step 16.
0615-03 Was Active for the Trans-
mission ECM and the Implement 1
ECM - Replace transmission ECM
(WP 0137) and implement 1 ECM
(WP 0268).
Proceed to step 16.
16. Connect secondary steering har-
ness connector AT-C3 (WP 0009,
Figure 144) to left articulation
angle position sensor (WP 0009,
Figure 145) (WP 0257).
17. Connect rear chassis wiring har-
ness connector FA-C22 (WP
0009, Figure 47) to cab lower wir-
ing harness connector P-C69
(WP 0009, Figure 46), and install
rear bulkhead cover plate (WP
0266).
0017-51