TM 5-3805-293-23-2
0042
TEST 2 POSITIVE BATTERY CABLE CONTINUED
00042
4. Remove cover (Figure 10, Item 5) from NATO slave receptacle (Figure 10, Item 3).
5. Using digital multimeter, measure voltage between inner contact (Figure 10, Item 4) (positive point) of NATO
slave receptacle (Figure 10, Item 3) and machine ground (Figure 10, Item 1). Voltage should not be less than 1
volt of value recorded in step 1.
a. If voltage is less than 1 volt of value recorded in step 1, replace positive battery cable (Figure 10, Item 2)
(WP 0195). End of Task.
b. If voltage is equal to value recorded in step 1, install cover (Figure 10, Item 5) on NATO slave receptacle
(Figure 10, Item 3) and proceed to step 6.
Figure 10. Positive Contact of NATO Slave Receptacle.
0042