TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1482-04 10 Volt Sensor DC
Power Supply Voltage Below
continuity between harness con-
harness (WP 0266).
Normal - Continued
nector P-C41 (WP 0009, Figure
Proceed to step 4.
68) terminal 69 and all other ter-
minals on harness connector P-
ECM (WP 0268).
C41 and to machine ground.
Connect harness connector P-C33
There should be no continuity.
(WP 0009, Figure 209) to scarifier
switch (WP 0275).
Connect harness connector PE-C8
(WP 0009, Figure 50) to right hand
joystick (WP 0283).
Proceed to step 4.
4. Using the MSD (WP 0006), select
1482-04 Code Active - Repeat
Trans/chassis 120M and verify
troubleshooting code from the
1482-04 is not active.
beginning.
1482-04 Code Not Active -
Troubleshooting complete.
System Response:
1558-09 Electronic Imple-
ment Control #2 Abnormal
ECM will log a diagnostic code.
Update Rate
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 1558-09
is Active.
1558-09 Code Active - Proceed to
Connect MSD (WP 0006), select
Test Step 2.
Implement 120M and verify 1558-09
is active.
1558-09 Code Not Active -
Troubleshooting complete.
Test Step 2. Test Voltage Supply
Circuit to Implement 2 ECM.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
0027-123