TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1558-09 Electronic Imple-
13. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
ment Control #2 Abnormal
continuity between harness con-
Proceed to Test Step 4.
Update Rate - Continued
nector P-C45 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
72) terminal 70 and machine
Replace cab lower wiring harness
ground.
(WP 0266).
Resistance should be less than
Proceed to step 14.
5.0 ohms.
14. Using MSD (WP 0006), select
1558-09 Code Active - Repeat
Implement 120M and verify 1558- troubleshooting from the beginning of
09 is not active.
this diagnostic code.
1558-09 Code Not Active -
Troubleshooting complete.
Test Step 4. Test Circuit.
1. Disconnect harness connector P-
C41 (WP 0009, Figure 68) from
implement 1 ECM J1 (WP 0009,
Figure 69) (WP 0268).
2. Install a jumper wire between har-
ness connector P-C41 (WP 0009,
Figure 68) terminal 10 and termi-
nal 20.
3. Using digital multimeter, test con-
Continuity - Proceed to Test Step 5.
tinuity between harness connec-
No Continuity - Replace cab lower
tor P-C45 (WP 0009, Figure 72)
wiring harness (WP 0266).
terminal 10 and terminal 20.
Connect harness connector P-C45
There should be no continuity.
(WP 0009, Figure 72) to implement 2
ECM J1 (WP 0009, Figure 73) (WP
0268).
Proceed to step 4.
4. Using MSD (WP 0006), select
1558-09 Code Remains Active -
Trans/Chassis 120M and verify
Repeat troubleshooting from the
1558-09 is not active.
beginning of this diagnostic code.
1558-09 Code Not Active -
Troubleshooting complete.
0027-127