TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1558-09 Electronic Imple-
10. Using MSD (WP 0006), select
1558-09 Code Active - Repeat
ment Control #2 Abnormal
Trans/Chassis 120M and verify
troubleshooting from the beginning of
Update Rate - Continued
1558-09 is not active.
this diagnostic code.
1558-09 Code Not Active -
Troubleshooting complete.
Test Step 3. Test Implement 2 ECM
Ground Circuit.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
N OT E
Harness connector is located behind cab bulkhead cover on right rear
of cab.
2. Remove rear bulkhead cover
plate (WP 0266).
3. Disconnect harness connector
FA-C22 (WP 0009, Figure 47)
from harness connector P-C69
(WP 0009, Figure 46) (WP 0188).
4. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between harness con-
Proceed to step 5.
nector FA-C22 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
47) terminal 67 and machine
Verify rear chassis ground (WP 0009,
ground.
Figure 133) is clean and tight. If
Resistance should be less than
ground is clean and tight replace rear
5.0 ohms.
chassis wiring harness (WP 0266).
Connect cab lower wiring harness
connector P-C45 (WP 0009, Figure
72) to Implement 2 ECM J1 (WP
0009, Figure 73).
Proceed to step 14.
5. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between harness con-
Proceed to step 6.
nector FA-C22 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
47) terminal 68 and machine
Verify rear chassis ground (WP 0009,
ground.
Figure 133) is clean and tight. If
Resistance should be less than
ground is clean and tight replace rear
5.0 ohms.
chassis wiring harness (WP 0266).
Connect cab lower wiring harness
connector P-C45 (WP 0009, Figure
72) to Implement 2 ECM J1 (WP
0009, Figure 73).
Proceed to step 14.
0027-125