TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1482-03 10 Volt Sensor DC
2. Disconnect harness connector P-
Power Supply Voltage
C41 (WP 0009, Figure 68) from
Above Normal - Continued
implement 1 ECM J1 (WP 0009,
Figure 69).
3. Disconnect harness connector
PE-C8 (WP 0009, Figure 50) from
right hand joystick (WP 0283).
4. Disconnect harness connector P-
C33 (WP 0009, Figure 209) from
scarifier switch (WP 0009, Figure
210) (WP 0275).
5. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between harness con-
harness (WP 0266).
nector P-C41 (WP 0009, Figure
Proceed to step 6.
68) and all other terminals on har-
No Continuity - Replace implement 1
ness connector P-C41.
ECM (WP 0268).
There should be no continuity.
Connect harness connector PE-C8
(WP 0009, Figure 50) to right hand
joystick (WP 0283).
Connect harness connector P-C33
(WP 0009, Figure 209) to scarifier
switch (WP 0009, Figure 210) (WP
0275).
Proceed to step 6.
6. Using the MSD (WP 0006), select
1482-03 Code Active - Repeat
Trans/chassis 120M and verify
troubleshooting code from the
1482-03 is not active.
beginning.
1482-03 Code Not Active -
Troubleshooting complete.
0027-120
