TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1473-14 Steering Control
Test Step 5. Test for Open Cab
Position Sensor #3 Special
Upper Wiring Harness to Imple-
Instruction - Continued
ment ECM.
1. Remove jumper wire from P-C48
(WP 0009, Figure 116) terminal 1
and P-C51 and terminal 3 (WP
0009, Figure 118).
2. Connect jumper wire between P-
C48 (WP 0009, Figure 116) termi-
nal 1 and terminal 3.
3. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between cab lower wir-
Replace transmission ECM (WP
ing harness connector P-C39
0137).
(WP 0009, Figure 70) terminal 34
Remove jumper wire from P-C48 (WP
and P-C41 (WP 0009, Figure 68)
0009, Figure 116) terminal 1 and
terminal 21.
terminal 3.
Resistance should be less than
Connect the cab lower wiring harness
5.0 ohms.
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 119) (WP 0282).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Connect cab lower wiring harness
connector P-C48 (WP 0009, Figure
116) to left hand joystick J3 (WP
0009, Figure 117) (WP 0282).
Connect rear chassis wiring harness
connector FA-C22 (WP 0009, Figure
47) to cab lower wiring harness
connector P- C69 (WP 0009, Figure
46) (WP 0266).
Proceed to step 4.
0027-118
