TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1558-09 Electronic Imple-
2. Disconnect cab lower wiring har-
ment Control #2 Abnormal
ness connector P-C45 (WP 0009,
Update Rate - Continued
Figure 72) from Implement 2 ECM
J1 (WP 0009, Figure 71) (WP
0268).
3. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between harness con-
harness (WP 0266).
nector P-C45 (WP 0009, Figure
Proceed to step 10.
72) terminal 31 and machine
No Continuity - Proceed to step 4.
ground.
There should be no continuity.
4. Turn battery disconnect switch
and ignition switch to the ON posi-
tion (TM 5-3805-293-10).
5. Using digital multimeter, test for
Voltage OK - Proceed to step 6.
voltage between harness connec-
Voltage Less Than 18 Volts -
tor P-C45 (WP 0009, Figure 72)
Replace cab lower wiring harness
terminal 31 and machine ground.
(WP 0266).
Voltage should be 18 to 26 volts.
Proceed to step 10.
6. Using digital multimeter, test for
Voltage OK - Proceed to step 7.
voltage between harness connec-
Voltage Less Than 18 Volts -
tor P-C45 (WP 0009, Figure 72)
Replace cab lower wiring harness
terminal 38 and machine ground.
(WP 0266).
Voltage should be 18 to 26 volts.
Proceed to step 10.
7. Using digital multimeter, test for
Voltage OK - Proceed to step 8.
voltage between harness connec-
Voltage Less Than 18 Volts -
tor P-C45 (WP 0009, Figure 72)
Replace cab lower wiring harness
terminal 39 and machine ground.
(WP 0266).
Voltage should be 18 to 26 volts.
Proceed to step 10.
8. Using digital multimeter, test for
Voltage OK - Proceed to step 9.
voltage P-C45 (WP 0009, Figure
Voltage Less Than 18 Volts -
72) terminal 46 and machine
Replace cab lower wiring harness
ground.
(WP 0266).
Voltage should be 18 to 26 volts.
Proceed to step 10.
9. Using digital multimeter, test for
Voltage OK - Proceed to Test Step 3.
voltage between harness connec-
Voltage Less Than 18 Volts -
tor P-C45 (WP 0009, Figure 72)
Replace cab lower wiring harness
terminal 47 and machine ground.
(WP 0266).
Voltage should be 18 to 26 volts.
Proceed to step 10.
0027-124
