TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1473-14 Steering Control
Resistance 5.0 Ohms or Greater -
Position Sensor #3 Special
Cab lower wiring harness is open,
Instruction - Continued
replace cab lower wiring harness (WP
0266).
Connect the rear chassis wiring
harness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Connect the rear chassis wiring
harness connector FA-C20 (WP 0009,
Figure 113) (WP 0137) to
transmission ECM J1 (WP 0009,
Figure 112).
Proceed to step 4.
4. Using the MSD (WP 0006), select
1473-14 Code Active - Repeat
Trans/chassis 120M and verify
troubleshooting code from the
1473-14 is not active.
beginning.
1473-14 Code Not Active -
Troubleshooting complete.
1482-03 10 Volt Sensor DC
System Response:
Power Supply Voltage
ECM will log a diagnostic code.
Above Normal
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 1482-03
is Active.
Connect MSD (WP 0006), select
1482-03 Code Active - Proceed to
Implement 120M and verify 1482-03
Test Step 2.
is active.
1482-03 Code Not Active -
Troubleshooting complete.
Test Step 2. Test Voltage Supply
Circuit.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
0027-119
