TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1473-14 Steering Control
2. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
Position Sensor #3 Special
resistance between cab lower wir-
Rear chassis wiring harness is open,
Instruction - Continued
ing harness connector P-C69
replace rear chassis wiring harness
(WP 0009, Figure 46) terminal 51
(WP 0188).
and terminal 28.
Remove jumper wire from P-C48
Resistance should be less than
terminal 1 and terminal 3 (WP 0009,
5.0 ohms.
Figure 116).
Connect cab lower wiring harness
connector P-C48 (WP 0009, Figure
116) to left hand joystick J3 (WP
0009, Figure 117) (WP 0282).
Connect the cab lower wiring harness
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 119) (WP 0282).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Cab lower wiring harness is open,
replace cab lower wiring harness (WP
0266).
Connect the rear chassis wiring
harness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Connect the rear chassis wiring
harness connector FA-C20 (WP 0009,
Figure 113) (WP 0137) to
transmission ECM J1 (WP 0009,
Figure 112).
Proceed to step 3.
3. Using the MSD (WP 0006), select
1473-14 Code Active - Repeat
Trans/chassis 120M and verify
troubleshooting code from the
1473-14 is not active.
beginning.
1473-14 Code Not Active -
Troubleshooting complete.
0027-117