TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1473-14 Steering Control
Test Step 1. Check for Other Codes.
Position Sensor #3 Special
1. Connect MSD (WP 0006), select
Instruction - Continued
Trans/chassis 120M and verify
1473-14 is active.
2. Check for Active code 1473-14
Code 1473-14 Active on Both
Implement 120M ECM (WP
Trans/Chassis and Implement
0006).
ECMs - Proceed to Test Step 2.
Code 1473-14 Active on Trans/
Chassis ECM Only - Proceed to Test
Step 3.
Test Step 2. Test for Signal Voltage
at LH Joystick.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the cab lower wiring
harness connector P-C48 (WP
0009, Figure 116) from LH joy-
stick connector J-3 (WP 0009,
Figure 117) (WP 0282).
3. Turn ignition switch and battery
disconnect switch to the ON posi-
tion.
4. Using digital multimeter, measure
Voltage OK (11.8 to 12.3 Volts) -
voltage between P-C48 terminal 1
Sensor signal circuit, transmission
(WP 0009, Figure 116) and termi-
and implement ECM OK. Replace LH
nal 3 (ground).
joystick (WP 0282).
Voltage should be 11.8 to 12.3 volts.
Proceed to step 5.
Voltage Not OK - Sensor signal
circuit shorted or transmission or
implement ECM bad, proceed to Test
Step 3.
5. Using the MSD (WP 0006), select
1473-14 Code Active - Repeat
Trans/chassis 120M and verify
troubleshooting code from the
1473-14 is not active.
beginning.
1473-14 Code Not Active -
Troubleshooting complete.
Test Step 3. Test for Open Rear
Chassis Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
0027-115
