TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0967-02 Machine Applica-
3. Using MSD (WP 0006), select
0967-02 Code Active - Replace the
tion Data Erratic, Intermit-
Implement 120M and verify 0967- implement 1 ECM (WP 0268) and the
tent or Incorrect Data -
02 is not active.
Messenger (WP 0272).
Continued
0967-02 Code Not Active -
Troubleshooting complete.
0967-09 Machine Applica-
System Response:
tion Abnormal Update Rate
ECM will log a diagnostic code.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 0967-09
is Active.
Connect MSD (WP 0006), select
0967-09 Code Active - Proceed to
Implement 120M and verify 0967-09
Test Step 2.
is active.
0967-09 Code Not Active -
Troubleshooting complete.
Test Step 2. Test Voltage Supply
and Ground Circuits.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect cab lower wiring har-
ness connector P-C93 (WP 0009,
Figure 163) from messenger (WP
0009, Figure 164) (WP 0272).
3. Turn battery disconnect switch
and ignition switch to the ON posi-
tion (TM 5-3805-293-10).
4. Using digital multimeter, test for
Voltage OK - Proceed to step 5.
voltage between harness connec-
Voltage Less Than 18 Volts -
tor P-C93 (WP 0009, Figure 163)
Replace cab lower wiring harness
terminal 1 and machine ground.
(WP 0266).
Voltage should be 18 to 26 volts.
Proceed to step 8.
0027-40
