TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1326-02 Implement 1 ECM
12. Using MSD (WP 0006), select
1326-02 Code Remains Active -
Location Code Data Erratic,
Implement 120M and verify 1326- Repeat troubleshooting from the
Intermittent or Incorrect -
02 is not active.
beginning of this diagnostic code.
Continued
1326-02 Code Not Active -
Troubleshooting complete.
Test Step 3. Test Rear Chassis Har-
ness Ground Circuits.
N OT E
Harness connector is located behind cab bulkhead cover on right rear
of cab.
1. Remove rear bulkhead cover
plate (WP 0266).
2. Disconnect harness connector
FA-C22 (WP 0009, Figure 47)
from harness connector P-C69
(WP 0009, Figure 46).
3. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between harness con-
Proceed to step 4.
nector FA-C22 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
47) terminal 25 and machine
Verify rear frame ground (WP 0009,
ground.
Figure 133) is clean and tight. If rear
Resistance should be less than
frame ground is not OK replace rear
5.0 ohms.
chassis wiring harness (WP 0188).
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement 1 ECM (WP 0009,
Figure 69) (WP 0268).
Proceed to step 6.
4. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between harness con-
Proceed to step 5.
nector FA-C22 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
47) terminal 67 and machine
Verify rear frame ground (WP 0009,
ground.
Figure 133) is clean and tight. If rear
Resistance should be less than
frame ground is not OK replace rear
5.0 ohms.
chassis wiring harness (WP 0188).
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement 1 ECM (WP 0009,
Figure 69) (WP 0268).
Proceed to step 6.
0027-44