TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-14 Machine Articula-
2. Using MSD (WP 0006), select
0615-14 Code Active - Repeat
tion Angle Sensor Special
Trans/Chassis 120M and verify
troubleshooting from the beginning of
Instruction - Continued
0615-14 is active.
this diagnostic code.
0615-14 Code Not Active -
Troubleshooting complete.
Test Step 4. Calibrate Sensor.
1. Calibrate articulation angle posi-
Articulation Angle Position Sensor
tion sensor 1 (left). Refer to Cali-
Cannot Be Calibrated - Perform
bration in WP 0257.
calibration procedure again. If sensor
cannot be calibrated, replace
articulation angle position sensor (WP
0257).
Proceed to step 2.
Articulation Angle Position Sensor
Calibrated OK - Proceed to step 2.
2. Connect MSD (WP 0006), select
0615-14 Code Active - Repeat
Trans/Chassis 120M and verify
troubleshooting from the beginning of
0615-14 is active.
this diagnostic code.
0615-14 Code Not Active -
Troubleshooting complete.
0650-02 Implement 2 ECM
System Response:
Harness Code Data Erratic,
ECM will log a diagnostic code.
Intermittent or Incorrect
N OT E
Data
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 0650-02
is Active.
0650-02 Code Active - Proceed to
Connect MSD (WP 0006), select
Test Step 2.
Implement Control #2 and verify
0650-02 is active.
0650-02 Code Not Active -
Troubleshooting complete.
Test Step 2. Test Messenger Volt-
age Supply and Ground Circuits.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
0027-36
