TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-08 Machine Articula-
2. Using MSD (WP 0006), verify
0615-08 Code Active - Proceed to
tion Angle Sensor Abnor-
0615-08 is active for the transmis-
Test Step 3.
mal Frequency, Pulse Width
sion ECM or the Implement 1
0615-08 Code Not Active -
or Period - Continued
ECM.
Troubleshooting complete.
Test Step 3. Check Sensor.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect secondary steering
harness connector AT-C3 (WP
0009, Figure 144) from left articu-
lation angle position sensor (WP
0009, Figure 145) (WP 0257).
3. Install a jumper wire between har-
ness connector AT-C3 (WP 0009,
Figure 144) terminal A and termi-
nal C.
4. Turn battery disconnect switch
and ignition switch to the ON posi-
tion (TM 5-3805-293-10).
5. Using MSD (WP 0006), verify
0615-03 Code Active - Proceed to
0615-03 is active.
step 6.
0615-03 Code Not Active - Proceed
to step 10.
6. Remove jumper wire from har-
ness connector AT-C3 (WP 0009,
Figure 144) terminal A and termi-
nal C.
7. Install a jumper wire between har-
ness connector AT-C3 (WP 0009,
Figure 144) terminal B and termi-
nal C.
8. Using MSD (WP 0006), verify
0615-04 Code Active - Replace
0615-04 is active.
articulation angle position sensor 1
(left) (WP 0257).
Proceed to step 10.
0615-04 Code Not Active - Proceed
to step 9.
0027-31
