TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
0615-03 Machine Articula-
tion Angle Sensor Voltage
Harness connector is located behind cab bulkhead cover on right rear
Above Normal - Continued
of cab.
3. Remove rear bulkhead cover
plate (WP 0266).
4. Disconnect rear chassis wiring
harness connector FA-C23 (WP
0009, Figure 17) from cab lower
wiring harness connector P-C71
(WP 0009, Figure 18).
5. Disconnect cab lower wiring har-
ness connector P-C41 (WP 0009,
Figure 68) from Implement 1 ECM
J1 (WP 0009, Figure 69) (WP
0268).
6. Install a jumper wire between har-
ness connector P-C41 (WP 0009,
Figure 68) terminal 44 and termi-
nal 45.
7. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between harness con-
Proceed to step 8.
nector FA-C23 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
17) terminal 4 and terminal 19.
Replace cab lower wiring harness
Resistance should be less than
(WP 0266).
5.0 ohms.
Connect secondary steering harness
connector AT-C3 (WP 0009, Figure
144) to left articulation angle position
sensor (WP 0009, Figure 145) (WP
0257).
Proceed to Step 10.
8. Disconnect rear chassis wiring
harness connector FA-C5 (WP
0009, Figure 111) from second-
ary steering wiring harness AT-C1
(WP 0009, Figure 110) (WP
0186).
0027-16
