TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-02 Machine Articula-
14.
Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
tion Angle Sensor Data
continuity between harness con-
Proceed to step 15.
Erratic, Intermittent or Incor-
nector AT-C1 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
rect - Continued
110) terminal 7 and harness con-
Replace secondary steering wiring
nector AT-C3 (WP 0009, Figure
harness (WP 0186).
144) terminal C.
Connect rear chassis wiring harness
Resistance should be less than
connector FA-C22 (WP 0009, Figure
5.0 ohms.
47) to cab lower wiring harness
connector P-C69 (WP 0009, Figure
46), and install rear bulkhead cover
plate (WP 0266).
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to Implement 1 ECM J1 (WP
0009, Figure 69) (WP 0268).
Connect cab lower wiring harness cab
lower wiring harness connector P-C39
(WP 0009, Figure 70) to Implement 1
ECM J2 (WP 0009, Figure 71) (WP
0268).
Connect harness connector FA-C21
(WP 0009, Figure 124) to
transmission ECM J2 (WP 0009,
Figure 112).
Proceed to step 19.
15. Using MSD (WP 0006), verify
0615-02 was active for the
0615-02 was active for the Trans-
transmission ECM only - Replace
mission ECM or the Implement 1
transmission ECM (WP 0137).
ECM.
Proceed to step 16.
0615-02 was active for the
implement 1 ECM only - Replace
implement 1 ECM (WP 0268).
Proceed to step 16.
0615-02 was active for the
transmission ECM and the
implement 1 ECM - Replace
transmission ECM (WP 0137) and
implement 1 ECM (WP 0268).
Proceed to step 16.
16. Connect secondary steering har-
ness connector AT-C3 (WP 0009,
Figure 144) to left articulation
angle position sensor (WP 0009,
Figure 145) (WP 0257).
0027-11
