TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-03 Machine Articula-
12. Using digital multimeter, test for
Continuity - Replace rear chassis
tion Angle Sensor Voltage
continuity between harness con-
wiring harness (WP 0188).
Above Normal - Continued
nector FA-C21 (WP 0009, Figure
Connect cab lower wiring harness
124) terminal 41 and all other ter-
connector P-C41 (WP 0009, Figure
minals on FA-C21.
68) to Implement 1 ECM J1 (WP
There should be no continuity.
0009, Figure 69) and harness
connector P-C39 (WP 0009, Figure
70) to Implement 1 ECM J2 (WP
0009, Figure 71) (WP 0268).
Connect secondary steering harness
connector AT-C3 (WP 0009, Figure
144) to left articulation angle position
sensor (WP 0009, Figure 145) (WP
0257).
Proceed to step 19.
No Continuity - Proceed to step 13.
13. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between harness con-
Proceed to step 14.
nector FA-C21 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
124) terminal 41 and harness
Replace rear chassis wiring harness
connector FA-C5 (WP 0009, Fig-
(WP 0188).
ure 111) terminal 7.
Connect cab lower wiring harness
Resistance should be less than
connector P-C41 (WP 0009, Figure
5.0 ohms.
68) to Implement 1 ECM J1 (WP
0009, Figure 69) and harness
connector P-C39 (WP 0009, Figure
70) to Implement 1 ECM J2 (WP
0009, Figure 71) (WP 0268).
Connect secondary steering harness
connector AT-C3 (WP 0009, Figure
144) to left articulation angle position
sensor (WP 0009, Figure 145) (WP
0257).
Proceed to step 19.
0027-20
