TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-03 Machine Articula-
Resistance 5.0 Ohms or Less -
tion Angle Sensor Voltage
Replace secondary steering wiring
Above Normal - Continued
wiring harness connector FA-C23
harness (WP 0186).
(WP 0009, Figure 17) terminal 4
Connect rear chassis wiring harness
and rear chassis wiring harness
connector FA-C23 (WP 0009, Figure
connector FA-C5 (WP 0009, Fig-
17) to cab lower wiring harness
ure 111) terminal 6.
connector P-C71 (WP 0009, Figure
18), and install rear bulkhead cover
5.0 ohms.
plate (WP 0266).
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to Implement 1 ECM J1 (WP
0009, Figure 69) (WP 0268).
Proceed to step 10.
Replace rear chassis wiring harness
(WP 0188).
Connect secondary steering harness
connector AT-C3 (WP 0009, Figure
144) to left articulation angle position
sensor (WP 0009, Figure 145) (WP
0257).
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to Implement 1 ECM J1 (WP
0009, Figure 69) (WP 0268).
Proceed to step 10.
10. Using MSD (WP 0006), select
0615-03 Code Active - Repeat
Trans/Chassis 120M and verify
troubleshooting from the beginning of
0615-03 is active.
this diagnostic code.
0615-03 Code Not Active -
Troubleshooting complete.
Test Step 5. Check Sensor.
1. Using MSD (WP 0006), verify
0615-03 Code Active - Proceed to
0615-03 is active.
Test Step 6.
0615-03 Code Not Active - Replace
left articulation angle sensor (sensor
1) (WP 0257).
Proceed to step 2.
2. Using MSD (WP 0006), select
0615-03 Code Active - Repeat
Trans/Chassis 120M and verify
troubleshooting from the beginning of
0615-03 is active.
this diagnostic code.
0615-03 Code Not Active -
Troubleshooting complete.
0027-17