TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-03 Machine Articula-
Test Step 6. Check Sensor Signal
tion Angle Sensor Voltage
Circuit.
Above Normal - Continued
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect harness connector
FA-C21 (WP 0009, Figure 124)
from transmission ECM J2 (WP
0009, Figure 112).
N OT E
Harness connector is located behind cab bulkhead cover on right rear
of cab.
3. Remove rear bulkhead cover
plate (WP 0266).
4. Disconnect rear chassis wiring
harness connector FA-C22 (WP
0009, Figure 47) from cab lower
wiring harness connector P-C69
(WP 0009, Figure 46) (WP 0188).
5. Disconnect cab lower wiring har-
ness connector P-C39 (WP 0009,
Figure 70) from Implement 1 ECM
J2 (WP 0009, Figure 71) (WP
0268).
6. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between harness con-
Replace cab lower wiring harness
nector P-C39 (WP 0009, Figure
(WP 0266).
70) terminal 41 and all other ter-
Connect harness connector FA-C21
minals on P-C39.
(WP 0009, Figure 124) to
Resistance should be less than
transmission ECM J2 (WP 0009,
5.0 ohms.
Figure 112).
Connect secondary steering harness
connector AT-C3 (WP 0009, Figure
144) to left articulation angle position
sensor (WP 0009, Figure 145) (WP
0257).
Proceed to step 19.
Resistance More Than 5.0 Ohms -
Proceed to step 7.
0027-18