TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-03 Machine Articula-
7. Disconnect cab lower wiring har-
tion Angle Sensor Voltage
ness connector P-C41 (WP 0009,
Above Normal - Continued
Figure 68) from Implement 1 ECM
J1 (WP 0009, Figure 69) (WP
0268).
8. Disconnect rear chassis wiring
harness connector FA-C23 (WP
0009, Figure 17) from cab lower
wiring harness connector P-C71
(WP 0009, Figure 18) (WP 0188).
9. Install a jumper wire between har-
ness connector P-C39 (WP 0009,
Figure 70) terminal 41 and har-
ness connector P-C41 (WP 0009,
Figure 68) terminal 44.
10. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between harness con-
Proceed to step 11.
nector P-C69 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
46) terminal 26 and harness con-
Replace cab lower wiring harness
nector P-C71 (WP 0009, Figure
(WP 0266).
18) terminal 19.
Connect secondary steering harness
Resistance should be less than
connector AT-C3 (WP 0009, Figure
5.0 ohms.
144) to left articulation angle position
sensor (WP 0009, Figure 145) (WP
0257).
Connect harness connector FA-C21
(WP 0009, Figure 124) to
transmission ECM J2 (WP 0009,
Figure 112).
Proceed to step 19.
11. Disconnect rear chassis wiring
harness connector FA-C5 (WP
0009, Figure 111) from second-
ary steering wiring harness AT-C1
(WP 0009, Figure 110) (WP
0186).
0027-19