TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-03 Machine Articula-
14. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
tion Angle Sensor Voltage
continuity between secondary
Proceed to step 15.
Above Normal - Continued
steering wiring harness AT-C1
Resistance More Than 5.0 Ohms -
(WP 0009, Figure 110)verify
Replace secondary steering wiring
terminal 7 and harness connector
harness (WP 0186).
AT-C3 (WP 0009, Figure 144)
Connect rear chassis wiring harness
terminal C.
connector FA-C23 (WP 0009, Figure
Resistance should be less than
17) to cab lower wiring harness
5.0 ohms.
connector P-C71 (WP 0009, Figure
18) (WP 0188).
Connect rear chassis wiring harness
connector FA-C22 (WP 0009, Figure
47) to cab lower wiring harness
connector P-C69 (WP 0009, Figure
46), and install rear bulkhead cover
plate (WP 0266).
Connect cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to Implement 1 ECM J2 (WP
0009, Figure 71) (WP 0268).
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to Implement 1 ECM J1 (WP
0009, Figure 69) (WP 0268).
Connect harness connector FA-C21
(WP 0009, Figure 124) to
transmission ECM J2 (WP 0009,
Figure 112).
Proceed to step 19.
0027-21