TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-02 Machine Articula-
17.
Connect rear chassis wiring har-
tion Angle Sensor Data
ness connector FA-C22 (WP
Erratic, Intermittent or Incor-
0009, Figure 47) to cab lower wir-
rect - Continued
ing harness connector P-C69
(WP 0009, Figure 46), and install
rear bulkhead cover plate (WP
0266).
18. Connect cab lower wiring harness
connector P-C41 (WP 0009, Fig-
ure 68) to Implement 1 ECM J1
(WP 0009, Figure 69) (WP 0268).
0615-02 Code Active - Repeat
19. Using MSD (WP 0006), select
Trans/Chassis 120M and verify
troubleshooting from the beginning of
0615-02 is active.
this diagnostic code.
0615-02 Code Not Active -
Troubleshooting complete.
System Response:
0615-03 Machine Articula-
tion Angle Sensor Voltage
ECM will log a diagnostic code.
Above Normal
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 0615-03
is Active.
0041-03 or 0041-04 Code Active -
1. Connect MSD (WP 0006), select
Diagnose 0041-03 or 0041-04 (WP
Implement 120M and verify 0041-
0026) for the Implement 1 ECM first.
03 or 0041-04 are active in the
Implement 120M ECM.
0041-03 or 0041-04 Code Not Active
- Proceed to step 2.
0615-03 Code Active - Proceed to
2. Using MSD (WP 0006), verify
Test Step 2.
0615-03 is active for the transmis-
sion ECM or the Implement 1
0615-03 Code Not Active -
ECM.
Troubleshooting complete.
0027-12
