TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0296-14 Transmission Con-
System Response:
trol Special Instruction
ECM will log a diagnostic code.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 0296-14
is Active.
1. Connect MSD (WP 0006). Select 0296-14 Code Active - Proceed to
Implement 120M and verify 0296- step 2.
14 is active.
0296-14 Code Not Active -
Troubleshooting complete.
2. Using MSD (WP 0006), select
0247-14 Code Active - Proceed to
Implement 120M and verify 0247- step 3.
14 or 0248-14 are active.
0248-14 Code Active - Proceed to
step 3.
3. Program the transmission ECM
and the implement ECM (WP
0008).
4. Using MSD (WP 0006), select
0296-14 Code Active - Replace the
Implement 120M and verify 0247- transmission ECM (WP 0137) and the
14 is not active.
implement ECM (WP 0268).
0296-14 Code Not Active -
Troubleshooting complete.
0026-47
