TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0358-05 Implement Pilot
5. Using the MSD (WP 0006), select 0358-05 Code Active - Repeat
Pressure Supply Solenoid
Implement 120M and verify 0358- troubleshooting code from the
Current Below Normal -
05 is not active.
beginning.
Continued
0358-05 Code Not Active -
Troubleshooting complete.
Test Step 3. Test for Open Cab
Lower Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the cab lower wiring
harness connector P-C39 (WP
0009, Figure 70) from implement
ECM J2 (WP 0009, Figure 71)
(WP 0268).
3. Using digital multimeter, measure
Resistance 5.0 Ohms or Less -
for continuity between cab lower
Replace implement 1 ECM (WP
wiring harness connector P-C39
0268).
(WP 0009, Figure 70) terminal 7
Remove jumper wire between
and terminal 8.
hydraulic valve wiring harness
Resistance should be 5.0 ohms or
connector AP-C3 (WP 0009, Figure
less.
215) terminal 1 and terminal 2.
Connect the hydraulic valve wiring
harness connector AP-C3 (WP 0009,
Figure 215) to implement pilot
pressure supply solenoid (WP 0009,
Figure 216).
Proceed to step 4.
Resistance 5.0 Ohms or Greater -
Proceed to Test Step 4.
4. Using the MSD (WP 0006), select 0358-05 Code Active - Repeat
Implement 120M and verify 0358- troubleshooting code from the
05 is not active.
beginning.
0358-05 Code Not Active -
Troubleshooting complete.
Test Step 4. Test for Open Rear
Chassis Wiring Harness.
1. Disconnect the rear chassis wir-
ing harness connector FA-C22
(WP 0009, Figure 47) from cab
lower wiring harness connector P-
C69 (WP 0009, Figure 46) (WP
0188).
0026-52