TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0296-12 Transmission
2. Disconnect harness connector
Control Abnormal Update
FA-C20 (WP 0009, Figure 113)
Rate - Continued
from transmission ECM J1 (WP
0009, Figure 112).
3. Install a jumper wire between con-
nector FA-C20 (WP 0009, Figure
113) terminals 10 and terminal 20.
Proceed to Test Step 6.
nector P-C41 (WP 0009, Figure
68) terminal 10 and terminal 20.
Proceed to Test Step 5.
Resistance should be less than
5.0 ohms.
Test Step 5. Test Cat Data Link Cir-
cuit from Rear Chassis Wiring Har-
ness.
1. Disconnect harness connector
FA-C22 (WP 0009, Figure 47)
from connector P-C69 (WP 0009,
Figure 46) (WP 0188).
resistance between harness con-
Replace cab lower wiring harness
nector FA-C22 (WP 0009, Figure
(WP 0266).
47) terminal 64 and terminal 65.
Remove jumper wire between
Resistance should be less than
connector FA-C20 (WP 0009, Figure
5.0 ohms.
113) terminals 10 and terminal 20.
Connect harness connector FA-C20
(WP 0009, Figure 113) to
transmission ECM J1 (WP 0009,
Figure 112).
Proceed to step 3.
Replace rear chassis wiring harness
(WP 0188).
Connect harness connector P-C41
(WP 0009, Figure 68) to implement
ECM J1 (WP 0009, Figure 69) (WP
0268).
Proceed to step 3.
0026-44