TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0296-12 Transmission
6. Using MSD (WP 0006), select
0296-12 Code Remains Active -
Control Abnormal Update
Implement 120M and verify 0296- Repeat troubleshooting from the
Rate - Continued
12 is not active.
beginning of this diagnostic code.
0296-12 Code Not Active -
Troubleshooting complete.
Test Step 7. Test CAN Data Link Cir-
cuit from Rear Chassis Wiring Har-
ness.
1. Disconnect harness connector
FA-C22 (WP 0009, Figure 47)
from connector P-C69 (WP 0009,
Figure 46) (WP 0188).
2. Using digital multimeter, test
Resistance 5.0 Ohms or Less -
resistance between harness con-
Replace cab lower wiring harness
nector FA-C22 (WP 0009, Figure
(WP 0266).
47) terminal 8 and terminal 9.
Remove jumper wire between
Resistance should be less than
harness connector FA-C21 (WP 0009,
5.0 ohms.
Figure 124) terminals 67 and terminal
68.
Connect harness connector FA-C21
(WP 0009, Figure 124) to
transmission ECM J2 (WP 0009,
Figure 112).
Connect harness connector FA-C20
(WP 0009, Figure 113) to
transmission ECM J1 (WP 0009,
Figure 112).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Replace rear chassis wiring harness
(WP 0188).
Connect harness connector P-C39
(WP 0009, Figure 70) to implement
ECM J2 (WP 0009, Figure 71) (WP
0268).
Connect harness connector P-C41
(WP 0009, Figure 68) to implement
ECM J1 (WP 0009, Figure 69) (WP
0268).
Proceed to step 3.
3. Using MSD (WP 0006), select
0296-12 Code Remains Active -
Implement 120M and verify 0296- Repeat troubleshooting from the
12 is not active.
beginning of this diagnostic code.
0296-12 Code Not Active -
Troubleshooting complete.
0026-46
