TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0296-12 Transmission
3. Using MSD (WP 0006), select
0296-12 Code Remains Active -
Control Abnormal Update
Implement 120M and verify 0296- Repeat troubleshooting from the
Rate - Continued
12 is not active.
beginning of this diagnostic code.
0296-12 Code Not Active -
Troubleshooting complete.
Test Step 6. Test CAN Data Link Cir-
cuit from Cab Lower Wiring Har-
ness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect harness connector P-
C39 (WP 0009, Figure 70) from
implement ECM J2 (WP 0009,
Figure 71) (WP 0268).
3. Disconnect harness connector
FA-C21 (WP 0009, Figure 124)
from transmission ECM J2 (WP
0009, Figure 112).
4. Install a jumper wire between har-
ness connector FA-C21 (WP
0009, Figure 124) terminals 67
and terminal 68.
Resistance Less Than 5.0 Ohms -
resistance between harness con-
Replace transmission ECM (WP
nector P-C39 (WP 0009, Figure
0137).
70) terminal 67 and terminal 68.
Remove jumper wire between
harness connector FA-C21 (WP 0009,
5.0 ohms.
Figure 124) terminals 67 and terminal
68.
Connect harness connector P-C39
(WP 0009, Figure 70) to implement
ECM J2 (WP 0009, Figure 71) (WP
0268).
Connect harness connector P-C41
(WP 0009, Figure 68) to implement
ECM J1 (WP 0009, Figure 69) (WP
0268).
Proceed to step 6.
Proceed to Test Step 7.
0026-45