TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0296-12 Transmission
Voltage OK - Proceed to step 7.
Control Abnormal Update
voltage between harness connec-
Voltage Less Than 18 Volts -
Rate - Continued
tor P-C41 (WP 0009, Figure 68)
Replace cab lower wiring harness
terminal 38 and machine ground.
(WP 0266).
Voltage should be 18 - 26 volts.
Proceed to step 10.
Voltage OK - Proceed to step 8.
voltage between harness connec-
Voltage Less Than 18Volts- Replace
tor P-C41 (WP 0009, Figure 68)
cab lower wiring harness (WP 0266).
terminal 39 and machine ground.
Proceed to step 10.
Voltage should be 18 - 26 volts.
Voltage OK - Proceed to step 9.
voltage between harness connec-
Voltage Less Than 18 Volts -
tor P-C41 (WP 0009, Figure 68)
Replace cab lower wiring harness
terminal 46 and machine ground.
(WP 0266).
Voltage should be 18 - 26 volts.
Proceed to step 10.
Voltage OK - Proceed to Test Step 3.
voltage between harness connec-
Voltage Less Than 18 Volts -
tor P-C41 (WP 0009, Figure 68)
Replace cab lower wiring harness
terminal 49 and machine ground.
(WP 0266).
Voltage should be 18 - 26 volts.
Proceed to step 10.
10. Using MSD (WP 0006), select
0296-12 Code Active - Repeat
Implement 120M and verify 0296- troubleshooting from the beginning of
12 is not active.
this diagnostic code.
0296-12 Code Not Active -
Troubleshooting complete.
Test Step 3. Test Ground Circuit.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
N OT E
Harness connector is located behind cab bulkhead cover on right rear
of cab.
2. Remove rear bulkhead cover
plate (WP 0266).
3. Disconnect harness connector
FA-C22 (WP 0009, Figure 47)
from harness connector P-C69
(WP 0009, Figure 46) (WP 0188).
0026-41