TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0296-12 Transmission Con-
System Response:
trol Abnormal Update Rate
ECM will log a diagnostic code.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 0296-12
is Active.
1. Connect MSD (WP 0006). Select 0296-12 Code Active - Proceed to
Implement 120M and verify 0296- Test Step 2.
12 is active.
0296-12 Code Not Active -
Troubleshooting complete.
Test Step 2. Test Voltage Supply
Circuit.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect cab lower wiring har-
ness connector P-C41 (WP 0009,
Figure 68) from Implement 1 ECM
J1 (WP 0009, Figure 69).
continuity between harness con-
harness (WP 0266).
nector P-C41 (WP 0009, Figure
Proceed to step 10.
68) terminal 31 and machine
ground.
There should be no continuity.
4. Turn battery disconnect switch
and ignition switch to the ON posi-
tion (TM 5-3805-293-10).
Voltage OK - Proceed to step 6.
voltage between harness connec-
Voltage Less Than Specified Range
tor P-C41 (WP 0009, Figure 68)
- Replace cab lower wiring harness
terminal 31 and machine ground.
(WP 0266).
Voltage should be 18 - 26 volts.
Proceed to step 10.
0026-40