TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0296-09 Transmission
Test Step 5. Test CAN Data Link Cir-
Control Abnormal Update
cuit from Rear Chassis Wiring Har-
Rate - Continued
ness.
1. Disconnect harness connector
FA-C22 (WP 0009, Figure 47)
from connector P-C69 (WP 0009,
Figure 46) (WP 0188).
2. Using digital multimeter, test
Resistance Less Than 5.0 Ohms -
resistance between harness con-
Replace cab lower wiring harness
nector FA-C22 (WP 0009, Figure
(WP 0266).
47) terminal 8 and terminal 9.
Remove jumper wire between engine
Resistance should be less than
ECM harness connector FA-C17 (WP
5.0 ohms.
0009, Figure 14) terminals 20 and
terminal 21.
Connect harness connector FA-C17
(WP 0009, Figure 14) to engine ECM
J1.
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Replace rear chassis wiring harness
(WP 0188).
Connect harness connector P-C39
(WP 0009, Figure 70) to implement
ECM J2 (WP 0009, Figure 71) (WP
0268).
Proceed to step 3.
3. Using MSD (WP 0006), select
0296-09 Code Remains Active -
Implement 120M and verify 0296- Repeat troubleshooting from the
09 is not active.
beginning of this diagnostic code.
0296-09 Code Not Active -
Troubleshooting complete.
0026-39