TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0296-09 Transmission
5. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
Control Abnormal Update
continuity between harness con-
Replace engine ECM (WP 0067).
Rate - Continued
nector P-C41 (WP 0009, Figure
Connect harness connector P-C41
68) terminal 10 and terminal 20.
(WP 0009, Figure 68) to implement
Resistance should be less than
ECM J1 (WP 0009, Figure 69) (WP
5.0 ohms.
0268).
Proceed to step 6.
Resistance 5.0 Ohms or Greater -
Proceed to Test Step 3.
6. Using MSD (WP 0006), select
0296-09 Code Remains Active -
Implement 120M and verify 0296- Repeat troubleshooting from the
09 is not active.
beginning of this diagnostic code.
0296-09 Code Not Active -
Troubleshooting complete.
Test Step 3. Test Cat Data Link Cir-
cuit from Rear Chassis Wiring Har-
ness.
1. Disconnect harness connector
FA-C22 (WP 0009, Figure 47)
from connector P-C69 (WP 0009,
Figure 46) (WP 0188).
2. Using digital multimeter, test
Resistance Less Than 5.0 Ohms -
resistance between harness con-
Replace cab lower wiring harness
nector FA-C22 (WP 0009, Figure
(WP 0266).
47) terminal 64 and terminal 65.
Remove jumper wire between engine
Resistance should be less than
ECM harness connector FA-C17 (WP
5.0 ohms.
0009, Figure 14) terminals 23 and
terminal 24.
Connect harness connector FA-C17
(WP 0009, Figure 14) to engine ECM
J1.
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Replace rear chassis wiring harness
(WP 0188).
Connect harness connector P-C41
(WP 0009, Figure 68) to implement
ECM J1 (WP 0009, Figure 69) (WP
0268).
Proceed to step 3.
0026-37