TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0262-04 5 Volt DC Power
7. Disconnect harness connector
Supply Voltage Below Nor-
FA-C12 (WP 0009, Figure 134)
mal - Continued
from harness connector FH-C2
(WP 0009, Figure 135) (WP
0188).
8. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between harness con-
Replace rear chassis wiring harness
nector FA-C20 (WP 0009, Figure
(WP 0188).
113) terminal 11 and all other ter-
Connect harness connector FG-C2
minals on harness connector FA-
(WP 0009, Figure 137) to accumulator
C20 and to machine ground.
pressure sensor (WP 0179).
Resistance should be less than
Proceed to step 9.
5.0 ohms.
Resistance More Than 5.0 Ohms -
Replace starter wiring harness (WP
0065).
Connect harness connector FA-C20
(WP 0009, Figure 113) to
transmission ECM (WP 0009, Figure
112).
Proceed to step 9.
9. Using MSD (WP 0006), select
0262-04 Code Active - Repeat
Implement 120M ECM and verify
troubleshooting code from the
0262-04 is active.
beginning.
0262-04 Code Not Active -
Troubleshooting complete.
0026-35