TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0600-03 Hydraulic Oil Tem-
2. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
perature Sensor Voltage
sure resistance between P-C35
Replace AWD ECM (WP 0270).
Above Normal - Continued
terminal 22 (WP 0009, Figure 53)
Connect FA-C23 (WP 0009, Figure
and P-C71 terminal 22 (WP 0009,
17) on P-C71 (WP 0009, Figure 18)
Figure 18).
(WP 0188).
Connect AC-C5 (WP 0009, Figure 78)
on FA-C37 (WP 0009, Figure 79) (WP
0199).
Connect AC-C2 (WP 0009, Figure 76)
on AWD hydraulic temperature sensor
connector (WP 0009, Figure 77).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Replace cab lower wiring harness
(WP 0266).
Connect AC-C5 (WP 0009, Figure 78)
on FA-C37 (WP 0009, Figure 79) (WP
0199).
Connect AC-C2 (WP 0009, Figure 76)
on AWD hydraulic temperature sensor
connector (WP 0009, Figure 77).
Proceed to step 3.
3. Using the MSD (WP 0006), select
0600-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
0600-03 is not active.
0600-03 Code Not Active - Trouble-
shooting complete.
Test Step 11. Test A201-BK
Unswitched Battery (-) Circuit for
High Resistance or Open in Filter
Bypass, Pump Drive Solenoid Har-
ness.
1. Disconnect filter bypass, pump
drive solenoid AC-C5 harness
connector (WP 0009, Figure 78)
from rear chassis wiring FA-C37
harness connector (WP 0009,
Figure 79) (WP 0199).
2. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
sure resistance between AC-C5
Proceed to Test Step 12.
terminal 8 (WP 0009, Figure 78)
Resistance 5.0 Ohms or Greater -
and AC-C2 terminal 2 (WP 0009,
Replace filter bypass, pump drive
Figure 76).
solenoid wiring harness (WP 0199).
Proceed to step 3.
0013-42