TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0600-03 Hydraulic Oil Tem-
Test Step 4. Test G434-BU Hydrau-
perature Sensor Voltage
lic Oil Temp Signal Circuit for Short
Above Normal - Continued
to Other Circuits in Filter Bypass,
Pump Drive Solenoid Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect filter bypass, pump
drive solenoid harness connector
AC-C5 (WP 0009, Figure 78) from
rear chassis wiring harness con-
nector FA-C37 (WP 0009, Figure
79) (WP 0199).
3. Using a digital multimeter, test for
No Continuity - Proceed to step 4.
continuity between AC-C5 termi-
Continuity - Replace filter bypass,
nal 11 and all other circuits in AC-
pump drive solenoid wiring harness
C5 (WP 0009, Figure 78). There
(WP 0199).
should be no continuity.
Proceed to step 5.
4. Using a digital multimeter, test for
No Continuity - Proceed to Test Step
continuity between AC-C5 termi-
5.
nal 11 (WP 0009, Figure 78) and
Continuity - Replace filter bypass,
ground. There should be no conti-
pump drive solenoid wiring harness
nuity.
(WP 0199).
Proceed to step 5.
5. Using the MSD (WP 0006), select
0600-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
0600-03 is not active.
0600-03 Code Not Active - Trouble-
shooting complete.
Test Step 5. Test G434-BU Hydrau-
lic Oil Temp Signal Circuit for Short
to Other Circuits in Rear Chassis
Wiring Harness.
1. Disconnect rear chassis wiring
FA-C23 harness connector (WP
0009, Figure 17) from cab lower
wiring P-C71 harness connector
(WP 0009, Figure 18) (WP 0188).
2. Disconnect rear chassis wiring
FA-C35 harness connector (WP
0009, Figure 15) from cab lower
wiring P-C70 harness connector
(WP 0009, Figure 16) (WP 0188).
0013-37