TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0600-03 Hydraulic Oil Tem-
3. Using the MSD (WP 0006), select
0600-03 Code Active - Repeat trou-
perature Sensor Voltage
All Wheel Drive 120M and verify
bleshooting code from the beginning.
Above Normal - Continued
0600-03 is not active.
0600-03 Code Not Active - Trouble-
shooting complete.
Test Step 12. Test A201-BK
Unswitched Battery (-) Circuit for
High Resistance or Open in Rear
Chassis Wiring Harness.
1. Disconnect rear chassis wiring
FA-C35 harness connector (WP
0009, Figure 15) from cab lower
wiring P-C70 harness connector
(WP 0009, Figure 16) (WP 0188).
2. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
sure resistance between FA-C35
Proceed to Test Step 13.
terminal 23 (WP 0009, Figure 15)
Resistance 5.0 Ohms or Greater -
and FA-C37 terminal 8 (WP 0009,
Replace rear chassis wiring harness
Figure 79).
(WP 0188).
Connect AC-C2 (WP 0009, Figure 76)
on AWD hydraulic temperature sensor
connector (WP 0009, Figure 77).
Install front access cover (WP 0226).
Proceed to step 3.
3. Using the MSD (WP 0006), select
0600-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
0600-03 is not active.
0600-03 Code Not Active - Trouble-
shooting complete.
0013-43