TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0600-03 Hydraulic Oil Tem-
2. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
perature Sensor Voltage
sure resistance between P-C70
Connect FA-C35 (WP 0009, Figure
Above Normal - Continued
terminal 23 (WP 0009, Figure 16)
15) on P-C70 (WP 0009, Figure 16)
and ground.
(WP 0188).
Connect AC-C5 (WP 0009, Figure 78)
on FA-C37 (WP 0009, Figure 79) (WP
0199).
Connect AC-C2 (WP 0009, Figure 76)
on AWD hydraulic temperature sensor
connector (WP 0009, Figure 77).
Install seat assembly (WP 0284).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Replace cab lower wiring harness
(WP 0266).
Proceed to step 3.
3. Using the MSD (WP 0006), select
0600-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
0600-03 is not active.
0600-03 Code Not Active - Trouble-
shooting complete.
System Response:
0600-04 Hydraulic Oil Tem-
perature Sensor Voltage
All-Wheel Drive (AWD) Electronic
Below Normal
Control Module (ECM) will log a diag-
nostic code and a warning will appear
on the messenger while the diagnos-
tic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a
connection is found, correct the problem and verify that this diagnostic
code is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Test for Shorted AWD
Hydraulic Temperature Sensor.
1. Connect MSD (WP 0006). Select
All Wheel Drive 120M and verify
0600-04 is active.