TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0600-03 Hydraulic Oil Tem-
Test Step 13. Inspect Ground
perature Sensor Voltage
Points of Cab Lower Wiring Har-
Above Normal - Continued
ness.
Ground Point or Ring Terminal
1. Inspect ground points of cab
Dirty or Corroded - Clean as neces-
lower wiring harness (WP 0009,
sary.
Figure 65) (WP 0266) for dirt, cor-
rosion, and damage.
Connect FA-C35 (WP 0009, Figure
15) on P-C70 (WP 0009, Figure 16)
(WP 0188).
Connect AC-C5 (WP 0009, Figure 78)
on FA-C37 (WP 0009, Figure 79) (WP
0199).
Connect AC-C2 (WP 0009, Figure 76)
on AWD hydraulic temperature sensor
connector (WP 0009, Figure 77).
Proceed to step 2.
Ring Terminal Defective - Replace
cab lower wiring harness (WP 0266).
Connect AC-C5 (WP 0009, Figure 78)
on FA-C37 (WP 0009, Figure 79) (WP
0199).
Connect AC-C2 (WP 0009, Figure 76)
on AWD hydraulic temperature sensor
connector (WP 0009, Figure 77).
Proceed to step 2.
No Problem Found - Install cab lower
wiring harness terminals on ground
point with mounting hardware and
tighten securely. Proceed to Test Step
14.
0600-03 Code Active - Repeat trou-
2. Using the MSD (WP 0006), select
bleshooting code from the beginning.
All Wheel Drive 120M and verify
0600-03 is not active.
0600-03 Code Not Active - Trouble-
shooting complete.
Test Step 14. Test A201-BK
Unswitched Battery (-) Circuit for
High Resistance or Open in Cab
Lower Wiring Harness.
1. Disconnect cab lower wiring P-
C35 harness connector (WP
0009, Figure 53) from AWD ECM
J1 (WP 0009, Figure 54) (WP
0270).
0013-44