TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0600-04 Hydraulic Oil Tem-
2. Turn ignition switch and battery
perature Sensor Voltage
disconnect switch to the OFF
Below Normal - Continued
position.
3. Disconnect filter bypass, pump
drive solenoid AC-C2 harness
connector (WP 0009, Figure 76)
from AWD hydraulic temperature
sensor connector (WP 0009, Fig-
ure 77).
4. Turn battery disconnect switch
and ignition switch to the ON posi-
tion.
5. Check for Active code 0600-03 or
Code 0600-04 Remains Active - Pro-
0600-04 in All Wheel Drive 120M
ceed to Test Step 2.
ECM (WP 0006).
Code 0600-04 Becomes Inactive
and 0600-03 Becomes Active -
Replace AWD hydraulic temperature
sensor (WP 0252).
Proceed to step 6.
6. Using the MSD (WP 0006), select
0600-04 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
0600-04 is not active.
0600-04 Code Not Active - Trouble-
shooting complete.
Test Step 2. Test for Shorted Filter
Bypass, Pump Drive Solenoid Har-
ness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect filter bypass, pump
drive solenoid AC-C5 harness
connector (WP 0009, Figure 78)
from rear chassis wiring FA-C37
harness connector (WP 0009,
Figure 79) (WP 0199).
3. Turn battery disconnect switch
and ignition switch to the ON posi-
tion.
4. Check for Active code 0600-03 or
Code 0600-04 Remains Active - Pro-
0600-04 in All Wheel Drive 120M
ceed to Test Step 3.
ECM (WP 0006).
Code 0600-04 Becomes Inactive
and 0600-03 Becomes Active -
Replace filter bypass, pump drive
solenoid wiring harness (WP 0199).
Proceed to step 5.
0013-46
