TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0600-03 Hydraulic Oil Tem-
2. Using a digital multimeter, mea-
Voltage Greater Than 0.3 Volts -
perature Sensor Voltage
sure voltage between P-C35 ter-
Replace cab lower wiring harness
Above Normal - Continued
minal 22 (WP 0009, Figure 53)
(WP 0266).
and ground.
Connect AC-C5 (WP 0009, Figure 78)
on FA-C37 (WP 0009, Figure 79) (WP
0199).
Connect AC-C2 (WP 0009, Figure 76)
on AWD hydraulic temperature sensor
connector (WP 0009, Figure 77).
Proceed to step 3.
Voltage 0.3 Volts or Lower - Replace
AWD ECM (WP 0270).
Connect FA-C35 (WP 0009, Figure
15) on P-C70 (WP 0009, Figure 16)
(WP 0188).
Connect FA-C23 (WP 0009, Figure
17) on P-C71 (WP 0009, Figure 18)
(WP 0188).
Connect AC-C5 (WP 0009, Figure 78)
on FA-C37 (WP 0009, Figure 79) (WP
0199).
Connect AC-C2 (WP 0009, Figure 76)
on AWD hydraulic temperature sensor
connector (WP 0009, Figure 77).
Proceed to step 3.
3. Using the MSD (WP 0006), select
0600-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
0600-03 is not active.
0600-03 Code Not Active - Trouble-
shooting complete.
Test Step 8. Test G434-BU Hydrau-
lic Oil Temp Signal Circuit for High
Resistance or Open in Filter
Bypass, Pump Drive Solenoid Har-
ness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect filter bypass, pump
drive solenoid AC-C5 harness
connector (WP 0009, Figure 78)
from rear chassis wiring FA-C37
harness connector (WP 0009,
Figure 79) (WP 0199).
0013-40