TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0600-03 Hydraulic Oil Tem-
3. Using a digital multimeter, test for
No Continuity - Proceed to step 4.
perature Sensor Voltage
continuity between P-C35 termi-
Continuity - Replace cab lower wiring
Above Normal - Continued
nal 22 and all other circuits in P-
harness (WP 0266).
C35 (WP 0009, Figure 53). There
Connect AC-C5 (WP 0009, Figure 78)
should be no continuity.
on FA-C37 (WP 0009, Figure 79) (WP
0199).
Connect AC-C2 (WP 0009, Figure 76)
on AWD hydraulic temperature sensor
connector (WP 0009, Figure 77).
Proceed to step 6.
4. Using a digital multimeter, test for
No Continuity - Proceed to step 5.
continuity between P-C35 termi-
Continuity - Replace cab lower wiring
nal 22 (WP 0009, Figure 53) and
harness (WP 0266).
all circuits in P-C37 (WP 0009,
Connect AC-C5 (WP 0009, Figure 78)
Figure 55). There should be no
on FA-C37 (WP 0009, Figure 79) (WP
continuity.
0199).
Connect AC-C2 (WP 0009, Figure 76)
on AWD hydraulic temperature sensor
connector (WP 0009, Figure 77).
Proceed to step 6.
5. Using a digital multimeter, test for
No Continuity - Proceed to Test Step
continuity between P-C35 termi-
7.
nal 22 (WP 0009, Figure 53) and
Continuity - Replace cab lower wiring
ground. There should be no conti-
harness (WP 0266).
nuity.
Connect AC-C5 (WP 0009, Figure 78)
on FA-C37 (WP 0009, Figure 79) (WP
0199).
Connect AC-C2 (WP 0009, Figure 76)
on AWD hydraulic temperature sensor
connector (WP 0009, Figure 77).
Proceed to step 6.
6. Using the MSD (WP 0006), select
0600-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
0600-03 is not active.
0600-03 Code Not Active - Trouble-
shooting complete.
Test Step 7. Test G434-BU Hydrau-
lic Oil Temp Signal Circuit for Short
to Other Voltage Source in Cab
Lower Wiring Harness.
1. Turn battery disconnect switch
and ignition switch to the ON posi-
tion.
0013-39