TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0600-03 Hydraulic Oil Tem-
3. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
perature Sensor Voltage
sure resistance between AC-C5
Proceed to Test Step 9.
Above Normal - Continued
terminal 11 (WP 0009, Figure 78)
Resistance 5.0 Ohms or Greater -
and AC-C2 terminal 1 (WP 0009,
Replace filter bypass, pump drive
Figure 76).
solenoid wiring harness (WP 0199).
Proceed to step 4.
4. Using the MSD (WP 0006), select
0600-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
0600-03 is not active.
0600-03 Code Not Active - Trouble-
shooting complete.
Test Step 9. Test G434-BU Hydrau-
lic Oil Temp Signal Circuit for High
Resistance or Open in Rear Chas-
sis Wiring Harness.
1. Disconnect rear chassis wiring
FA-C23 harness connector (WP
0009, Figure 17) from cab lower
wiring P-C71 harness connector
(WP 0009, Figure 18) (WP 0188).
2. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
sure resistance between FA-C23
Proceed to Test Step 10.
terminal 22 (WP 0009, Figure 17)
Resistance 5.0 Ohms or Greater -
and FA-C37 terminal 11 (WP
Replace rear chassis wiring harness
0009, Figure 79).
(WP 0188).
Connect AC-C2 (WP 0009, Figure 76)
on AWD hydraulic temperature sensor
connector (WP 0009, Figure 77).
Install front access cover (WP 0226).
Proceed to step 3.
3. Using the MSD (WP 0006), select
0600-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
0600-03 is not active.
0600-03 Code Not Active - Trouble-
shooting complete.
Test Step 10. Test G434-BU Hydrau-
lic Oil Temp Signal Circuit for High
Resistance or Open in Cab Lower
Wiring Harness.
1. Disconnect cab lower wiring P-
C35 harness connector (WP
0009, Figure 53) from AWD ECM
J1 (WP 0009, Figure 54) (WP
0270).
0013-41