TM 5-3805-263-14&P-1
20.
Remove the lower pivot pin and then the upper
pin.
NOTE
Turn the battery disconnect switch to the
’ON" position. At the operator’s console,
while holding the left blade control lever in
he "Blade Down" position, flip the auxliary
pump switch intermittently to remove any
load from the rear hitch area. Repeat with
the right control lever as needed. Turn the
disconnect switch "OFF."
(1)
Remove the outer circle of bolts from the top of
the pin and bottom cap.
(2)
Loosen bottom retainer bolts.
(3)
Install the two (2) special pusher bolts in the
holes provided at the top of the pin.
(4)
Tighten the bolts alternately to remove the pin.
104
